Note that this setting doesn't prevent Windows Update from offering and installing device drivers. When the Device installation settings window opens, select the second ( No) option then Save Changes. It is the only one, so you can't miss it. In the search results, click the Change device installation settings link. Open Control Panel then inside the search box at the top-right corner, type device installation. Using Group Policy Editor (gpedit.msc), you can prevent Windows Update from installing device drivers. Since you have Windows 10 Pro, you have better control over this behaviour. Proceed offline until you reach the desktop, then disable the automatic downloading of device drivers/software. I suggest you start again with a fresh clean installation of Windows 10 1903, but this time, do it OFFLINE, that is, unplug the ethernet connection and DO NOT connect to any wireless networks during the initial Windows setup. Sounds like an outdated or buggy driver is being automatically downloaded and installed via Windows Update. (Code 10) Wireless Network Adapter & HD Audio Controlle The Error disappears and reappears about 3 seconds later. The other two drivers install successfully. Note: The drivers from Intel and Microsoft (see screenshots) I cannot install, saying the device cannot be started (Code 10). If not, I apologize and will deliver further details immediately.Įdit: I also noticed that when I want to shut down my laptop, it instead turns off the screen and keyboard lights. I hope I covered all the information you need to understand my problem and also what my specs are. A quick look into the device manager revealed the same problem for the High Definition Audio Controller. Somewhere along the way I also noticed that my speakers aren't working anymore. About 3 minutes after (I did not install or update anything, at least not manually) WiFi disconnected and the same problem reappeared. I finished the setup and landed on my desktop screen. I deleted all files on my laptop and did a clean install of Windows.Īs the install finished and the initial setup begun I was prompted to choose an Internet connection and even my modem was shown and available. Running out of my known options, I prepared a bootable USB drive. While updating Windows, I noticed that there is a new version (1903), so I installed it. The adapter was still not working though. After all the updates I rebooted the Laptop and it started normally. Next thing I did was update all my other drivers and install all Windows updates (still version 1803). There i uninstalled the driver for the adapter again and rebooted. The blue screen kept reappearing.Īfter many reboots I got into safe mode. It took a long time to do so and when it finally booted a blue screen appeared (Thread_Handling_Exception or something like that) and it rebooted again and got stuck in a loop of reboots and the same blue screen until it put me to the screen where you have couple options for going to the BIOS or Diagnostic tools etc. I used the Killer uninstaller to uninstall all Killer software. While following those steps, weird things happened. Next thing I did was following those steps: Link to Killer support. As soon as I disconnected Ethernet, the same error reappeared. Windows reinstalled the driver and showed no error. Next I tried to uninstall the driver and reboot. It told me that the Killer(R) Wireless-AC 1550i Wireless Network Adapter (9560NGW) 160MHz cannot start (Code 10). Note: At that point my Windows version was 1803.įirst thing I did, was rebooting the Laptop. Monday I noticed, that I had no Internet and that the WiFi option is missing in the Network & Internet settings. Killer(R) Wireless-AC 1550i Wireless Network Adapter (9560NGW) 160MHz Since Monday my WiFi Adapter is not working anymore. (Code 10) Wireless Network Adapter & HD Audio Controller
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |